How to install resilient vinyl flooring at home

Flooring is needed by every household. Many families choose to install it by themselves to save a lot of money. Today the enmansenspc flooring manufacturer will introduce a tutorial on installing vinyl flooring at home.

The elastic tongue and groove vinyl floor can be installed on concrete, wood or vinyl, as long as the floor below it is flat and smooth. This is a floating floor with locking joints, which means it cannot be held in place by fasteners or adhesives. Make sure to leave the recommended gap between the floor and the wall for expansion and contraction.

To install resilient vinyl flooring:

How to start: Start with the first row, which runs parallel to the long wall of the room and is about 1/4 inch from it.

Lock joints: First lock the end joints of each part together, then lock the long side joints.

Cut to a certain length: Scratch the top of the floor with a utility knife, then break off from the bottom.

Trim edges: Apply shoes or quarter-round moldings to the wall. Pin the trim strips to the skirting boards, but not to the floor to allow the floor to move.

Organize the doorway: Put a threshold on the doorway, do not nail it to the floor to make it move.

The new resilient tongue and groove flooring materials are a good choice because they can be installed almost anywhere without the need for padding. The floor can cover almost any surface (concrete, wood or vinyl), but the underlying floor underneath does need to be smooth.

Because it's a floating floor, you can start near, but not close to a wall, and work from there. The remaining gap will later be covered by the shoe mold, keeping the floor down. Like most laminate floors, the tongue and groove connection on this floor has a locking function that requires a bit of rotational movement to snap it into place.

First align the short joints as close as possible on the longer joints, and then fasten the long and short joints almost simultaneously. It takes a little practice, but once you have practice, the work will be easy.

And because this thing is thick vinyl in nature, there is no need to saw it. All you have to do is score it with a utility knife and clean it. After every few lines in place, you will need a little weight to get over them to make sure they are locked.

After covering the area, you need to add shoe molds around the edge of the doorway and around the threshold to secure it in place.

Leave a Reply

Your email address will not be published. Required fields are marked *